Purchase one here
CAUTION: The Modstock assembly utilizes serrated spring steel washers to lock the pivot joints in place. Losing or omitting these washers will result in an unsecure lockup, and unintended rotation of the stock under recoil.
CAUTION: If coating your Modstock, the pivot joint areas must be masked off from paint. Changes in tolerance or lubricity due to coating ingress may result in poor function of the pivots or unsecure lockup.
INSTALLATION: With a flathead screwdriver, remove the stock attachment screw running from upper to lower tang on the receiver. Slide the factory wooden stock rearward, off the receiver. Sometimes a few bumps with the palm of your hand may be needed to free the stock.
Slide your new Ranger Point Modstock into place on the receiver tangs. Replace the attachment screw, or replace it with one of our quick detach butt stock screws. If preferred, add the included cheek pad onto the top strut (peel and stick).
ADJUST COMB HEIGHT: Using the supplied Allen key, slightly loosen the four ¼-28 pivot bolts. Rotate the stock until you have a perfect cheek weld for your sighting solution. Tighten the pivot bolts as tight as possible using the supplied Allen key. There is no recommended torque spec for this.
NOTE: you should always use the lowest scope rings possible. Your Modstock should offer a good cheek weld with a low mounted scope, but should you need more elevation than can be achieved with our AR-height cheek riser.
ADJUST LENGTH OF PULL (LOP):
The Ranger Point Modstock offers LOP adjustment by two means:
1) Interchangeable recoil pads. Our butt plate is made in the pattern of the common AR 6-position collapsible stock. Most, if not all recoil pads made for this stock will fit ours, and small changes in LOP may be achieved by fitting a different pad.
2) LOP shim/spacer (add-on when buying your stock). For very tall shooters (over 6’) Ranger Point offers a ½” spacer, available on our website. The spacer accepts the same recoil pad(s) as the butt plate.
ADD A SLING OR CARTRIDGE QUIVER:
The butt stock hardware packet includes one GrovTec Sling Swivel stud that attaches to the underside of the bottom strut. Additionally, our $20 accessory panel has two push button sling swivel holes for side attachment of a sling (the rear is the best). The panel also has M-LOK slots that you can use to attach one of our cartridge quivers in the caliber of your choice (opposite side of your face cheek weld). We recommend attaching the quiver with the RP Logo upside down so you can most easily pull the cartidges out and down for easier loading.
Comments
0 comments
Please sign in to leave a comment.