- Test fit the dovetail blank in the barrel cut. In most cases, it will slide in easily, or with gentle tapping. Do not attempt to drift the blank in with a punch, as this will damage the thin side edges.
- If the blank does not fit, use a file or sandpaper to remove material from the fore/aft sharp edges (not bevels). If removing a few thousands of an inch doesn't get a fit, the bottom of the blank may need to be lapped on fine sandpaper to loosen the overall fit. Cold blue may be used for touching up bare metal.
- Once a slip fit is achieved, degrease the blank and the dovetail cut, then apply red Loctite (or similar) generously to help fill voids and prevent rust. Wipe away excess and let set. Apply gun oil after adhesive sets.
Ranger Point profiled dovetail blanks are specially machined to mount flush on round rifle barrels. These already “profiled” dovetail blanks install in minutes and save you the 1-2 hours of filing necessary to fit other “blanks.”
Comments
0 comments
Please sign in to leave a comment.